Menu
Your Cart

PROFESSIONAL SPRAY GUN SUCTION CUP 1.4MM NOZZLE HVLP

HVLP spray gun 1.4mm

The success behind an HVLP spray gun, is the low amount of overspray.

This is achieved by having an improved atomization, by using a lower air pressure and a higher volume of airflow.

HVLP - High Volume Low Pressure

 

Tips and techniques

When sprayfinishing, it's always advised to keep the spray gun parallel to the workpiece surface. The distance from the surface of the workpiece should be the width of the spray pattern.

The lower the pressure of the air, the lower the chance to have bounce-back (overspray). The pressure should only be increased when the spray pattern is uneven - paint focused in the middle when the fan setting is wide.

Features:

  • Cast aluminium body construction
  • Suction feed cup allows for spray gun to placed down without a holder and holds greater capacity compared to a gravity feed spray gun
  • Easy spray pattern and fluid control adjustment
  • Stainless steel fluid tip and needle
  • Rotatable aircap to change spray pattern direction
consider safety for your health and the people around you

General safety suggestions:

It is advisable to always have the following items nearby and in a good condition

  • Eye protection – clean and scratch free
  • Hearing protection – quality earmuffs
  • Dust masks – discard old and dirty masks
  • Gloves – for easy handling of material and hand protection
Wear Gloves Eye Protection Hearing Protection Dust Mask
Wear Gloves
Eye Protection
Hearing Protection
Dust Mask
Description Specification
Working pressure  43-58 Psi (3 - 4 Bar)
Cup capacity 1000 ml (Aluminium)
Feed type Suction feed
Airflow consumption 340 l/min
Air inlet hread 1/4 BSP
Nozzle/Needle Ø 1.4mm
Pattern width 24cm

 

Download the Instruction Manual:
View the Instruction Manual:

Write a review

Note: HTML is not translated!
Bad Good